100A SCT-013-000 Non Invasive AC Current Sensor

900.00

Description

This non-invasive current sensor clamped around the supply line can measure a load up to 100 Amps, and allow you to calculate how much current pass through it. It can be useful for building your own energy monitor or for building an over-current protection device for an AC load. This current clamp can be used to detect a current of up to 100A. Simply clip it around the current source that you wish to measure and it will produce a (very) small AC voltage proportional to the current. The cable is terminated on one end with a standard 3.5mm jack (like a headphone jack).

Use this to build your own energy monitor and keep your power usage down, or use it to to build an over-current protection device for an AC load. See the link below for an example project. Check out the datasheet for the pinout of the 3.5mm jack.
Applications:

Suitable for the current measuring
Monitoring and protection of AC motor
Lighting equipment
Air compressor
Specifications:

Input Current: 0~100A AC
Output Mode: 0~50mA
Non-linearity: ?3%
Turn Ratio: 100A:0.05A
Resistance Grade: Grade B
Work Temperature: -25?C ~ 70?C
Leading Wire in Length: 1m
Non-invasive current transformer
Suitable for lighting equipment, AC motors, air compressors, monitoring, current measurement, and protection
Meet UL94-V0 flame retardant properties
Two form of output current, voltage (voltage output built-in the sampling resistor)
Non-linearity ?3%(10%-120% rated input current)
Model: SCT-013-000
Reference project: Open Energy Monitor
Core Material: Ferrite
Dielectric Strength: 6000V AC/1min
Input Current: 0A-100A
Anti-flaming rate: UL94-V0
Mechanical strength: opening and closing times, no less than 1000 times (20 ?)
Opening Size: Approx. 0.51 * 0.51inch / 13 x 13mm

Reviews

There are no reviews yet.

Be the first to review “100A SCT-013-000 Non Invasive AC Current Sensor”

No announcement available or all announcement expired.